What should be paid attention to when processing precision hardware parts?
The hardware mold processing industry is developing rapidly, and the competitive pressure for enterprises is also increasing day by day. Whether in processing technology or processing quality, they are constantly improving and innovating. In this fiercely competitive era, enterprises can only meet customer needs and win the market by ensuring good quality, good service, and continuous innovation ability. Today, let's popularize what to pay attention to when processing precision hardware parts?
1. Before starting the mechanical work, check whether the moving parts have been lubricated, then start and check whether the clutch and brake are normal, and run the machine idle for 1-3 minutes. It is strictly prohibited to operate the machine if there is a malfunction.
2. Maintain the correct posture while working and have sufficient mental energy to cope with the work. If you feel unwell, immediately leave your work post and report it to your leader. When operating, it is necessary to concentrate, prohibit casual conversation, and cooperate with each other. Operators should not operate in a restless or tired state to avoid accidents and ensure safe operation. All employees are required to check if their clothing meets the job requirements before entering the workplace. Do not wear slippers, high heels, or clothing that may affect safety. Those with long hair must wear a safety helmet.
3. When replacing the mold, the power should be turned off first, and the punching machine movement department should stop running before starting to install and debug the mold. After installation and adjustment, move the flywheel twice by hand to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the edge pressing ring is in a reasonable position.
4. It is necessary to wait for all other personnel to leave the mechanical work area and remove the debris from the workbench before starting the power supply to start the machinery.
5. During mechanical operation, it is strictly prohibited to insert hands into the sliding block working area, and it is strictly forbidden to use hands to take or place workpieces. When taking and placing workpieces in the die, it is necessary to use tools that meet the standards. If any abnormal noise or malfunction is found in the machinery, the power switch should be immediately turned off for inspection. After the machinery is started, one person is responsible for transporting materials and operating the machinery. Others are not allowed to press the power building or step on the foot switch board, nor can they put their hands into the mechanical work area or touch the moving parts of the machinery with their hands.
6. At the end of work, the idle power should be turned off and the finished products, scraps, and miscellaneous items on the job should be sorted out to ensure a clean and safe working environment.
